Already understand how to add inhibitor through the radiators, I must have misunderstood him and thought he was also suggesting it also be added via the boiler which go me wondering how do you do that. Solvent products could cause damage to the system. G Brown , Aug 13, When installing or servicing this boiler, care should be taken when handling the edges of sheet metal. The Building Standards Regulations Scotland. Can anyone advise me which is the right valve cold water outlet I believe to open to fill it?? Page of 31 Go.

protherm 80e manual

Uploader: Fauzshura
Date Added: 4 August 2007
File Size: 69.26 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 31507
Price: Free* [*Free Regsitration Required]

These instructions should be carefully followed for the safe and economical use of your boiler.

No fault codes displayed – has to be the PCB then. Wall-hang non-condensing boiler power 8,5 – 23,3 kw flow heating hw 41 pages.

Protherm 80E Manual Required

Connect the central heating pipework connections and isolating cocks as shown on diagram 6. The Building Standards Regulations Scotland. According to the manual this would indicate that “the domestic heat exchanger may be partially or fully blocked, the pump may be running too slowly or the central heating flow rate is to low”.


H stat on full. Isolation should preferably be by a double pole swit Share This Page Tweet. As a option the hanging bracket can be used. Now I understand you don’t. It’s 4 years old.

Protherm 80e Combi – no C/H | Screwfix Community Forum

Connect the hot water outlet connection. Log in or Sign up. The Protherm 80E boiler has a built-in frost protection device that protects the boiler during freezing conditions. Hang the boiler on the screws and tighten screws.

Protherm e combi boiler skim24 Novin forum: Page 28 Air pressure switch failure: JSMay 3, Your name or email address: The boiler serial number is marked on the data label attached to the fascia behind the front panel. So now I’m at a loss – he cleaned the domestic heat nanual – said the pump was working. ChrisR 14 Nov Wall hung combination boiler. Wall hung combination boiler.

protherm 80e manual

The black one to the left at the end of the braid. Check the flow switches 1st.


Protherm 80e Combi – no C/H

Page 19 18 electrical connection warning: Page 24 23 to replace pump drain down heating circuit only of boiler as follows: Connect the safety valve discharge pipe to the valve, the discharge must be extended using not less than 15 mm o. He protnerm wants it fixed for nothing.

The distribution system shall be ca Page of 31 Go. Plumbing and Central Heating.

protherm 80e manual

To gain access to the inside of the boiler undo screw securing front panel at the boiler bottom, remove front panel by pulling forwards, lifting it up and off. On completion, the gas installation must be tested using the pressure drop method and purged in accordance with.

protherm 80e manual

Gas Safety Installation and Use Regulations.